Examples of Custom FA fixtures
Custom FA/ENG Fixture: A complete unique solution observing all mechanical and electrical requirements for the most specific test applications. Custom FA and Engineering fixtures are designed to streamline the test process for bleeding edge technologies, or when a standard fixture cannot be used.
Daisy Chained Module Test Fixtures
This is a customer specific solution using a generic interchangeable test fixture base with a universal module specific socket. Conceptually similar to RTI's 950 Fixture.
Custom Universal Break Out BGA
Break out from RTI's Universal 0.5mm pitch BGA test socket to 100 pin Yamaichi® connectors. Backing plate adds durability and allows for use on vacuum surfaces.
Custom Hybrid Socket burn-in board & driver board
This system was designed to dynamically burn-in a custom multi-chip module with over 200 I/O on 0.8mm pitch. The custom RTI socket contains a heat sink that attaches to a larger heat sink on the back side of the burn-in board. The dual latch clip-on lid has an adjustable pressure plate using a brass machined knob for heat dissipation. The driver board interfaces to the burn-in board using feed-though ribbon cables through the back wall of the oven.
RTI designed both the sockets and static burn-in board for custom hybrid modules. Each socket holds 10 modules and has a common lid with individual pressure plates.
This fixture includes an RTI custom 97-pin 0.5mm pitch CSP production socket with an open-top FA lid (not shown) for micro probing and bench test. The fixture is used for DC and low frequency analysis only.
This fixture was design to perform liquid crystal analysis at the wafer level using a probe station and a hot chuck. The fixture includes a pogo ring interface to the probe cards, custom probe cards, and interface to 34 pin headers as will as all the mechanical interfaces.