RSK SERIES BREAKOUT FIXTURES

Low-profile breakout fixtures give you topside and backside access to the DUT and work equally well on the bench, with a probe station, or with your high-end inspection tools.

DESIGNED FOR ECONOMIC DEVICE INSPECTION

Focused on simple design and improved device access, the RSK-Series breakout fixtures were built with hand test, failure analysis and advanced inspection methods in mind. They feature a low profile 1.5” semi-custom test socket for any WLCSP or packaged device footprint with up to 384 channels and utilize a standard cable-connector based interface, making them a highly portable test solution for any lab.

RSK-Series Board Overview

All RSK-Series fixtures include these standard elements in different configurations depending on the model.

Standard & Custom Design Options

  • Compatible with all 1.5” RTI test socket designs, MultiTrace Curve Tracers, and 96 channel switchboxes
  • Custom standoff lengths between PCB and baseplate in 1/32” increments
  • Thumb screw assembly of board to baseplate for quick swapping between configurations (optional feature)

  • 96 channel, 100pin connectors installed on topside or bottom side of board
  • Header Pin Banks in close proximity to connector for manual probing or jumping
  • Heater block installed in socket with connector for use with RTI’s Temperature Controller Units
  • Higher pin count device testing available under certain conditions

Cables and Shorting Connectors

Standard cable lengths at 3ft and 6ft. Custom cable lengths between 1ft and 10ft

Shorting connectors – ties all signals on the connector to GND for rapid opens-diagnostics

Custom RSK Series Examples

Docking fixture for more permanent benchtop setups. Improved cable management and docking interface for all R1-R4 models with bottom side connectors

More Resources

Contact an Engineer

    Design & Concept Gallery

    MORE FIXTURE SOLUTIONS

    PCB Test Fixtures

    High-performance at a compact scale, our PCB test fixtures are built for singular and panelized PCB testing. Fixtures align and contact test points on your UUT(s) then route signals out to connectors of your choice.

    Mechanical Test Press Fixtures

    Manual or pneumatic presses for PCB, hybrid module, and device-level testing. Single-site or multi-site configurations offer rapid device loading and unloading. Test Presses ensure evenly distributed vertical compression force is applied to the UUT.

    Customization

    When a more customized test solution is required to meet your applications, device(s) and requirements. For PCB-based subassemblies and complex components.

    950 Series Test Fixture

    950 Series is capable of testing topside and backside, including micro-probing, backside emission microscopy, heated sockets for temperature testing, and curve tracing.

    Remote Docking

    Cable based interfaces that sit between your tester and your DUT board allowing you greater flexibility in where your DUT sits on your bench. Ideal for failure analysis, fault localization, or for use under a microscope.

    custom pogo pin blocks

    Pogo Pin Blocks

    Breakout test fixtures typically include a test socket and DUT board that route signals from your DUT to a connector or interface of choice. Transform your dedicated DUT board into a universal motherboard-daughterboard solution with pogo pin blocks that provide a board to board interface.

    QUALITY GUARANTEE

    Robson Technologies, Inc. interconnects, fixtures and systems are carefully designed, manufactured, inspected, and individually tested prior to shipment. In the unlikely case you find a defect in materials or workmanship, we will promptly repair or replace the component.

    CONTACT US

    Do you need help finding a test solution? Get in touch with an RTI Engineer!

    OFFICE LINE

    OFFICE HOURS

    8:00am – 5:00pm PT

    OFFICE LINE

    OFFICE HOURS

    8:00am – 5:00pm PT